Primarily for the MGB, some of these parts can be used with other LBC's

REMOTE BONNET RELEASE (USE WITH OR WITHOUT ORIGINAL RELEASE) $18.00
Add this item to your shopping cart - you can always remove it later!
In the parking lot at the last meeting a member noticed and asked about the extra wire on my bonnet latch. I told him about the Remote Bonnet Release that attaches to the lever and exits into the left side front wheel well. If the original release cable should break, this cable serves as an emergency release. It also comes in handy as an alternative if you don't want to reach into the car to pull the original release handle.

The instructions call for drilling a hole in the inner fender wall but I didn't find that to be necessary. I simply routed it through the grommet for the headlight wiring. That leaves it only a bit harder to reach but it's better than the alternatives should the original release cable break.

Just installed the cable. The small end had to be pushed on hard but it went on. The unit functions well. I give it a 10. You can pass on my recommendation.  - John P. -FL.

 

STAINLESS or BLACK STALK BUTTONS FITS 68-76 MGB(AVOID THAT RUSTY LOOK) ($8.00 Pair)
Add this item to your shopping cart - you can always remove it later! Stainless Steel
Add this item to your shopping cart - you can always remove it later! Black
CONNECTOR CLEANING BRUSHES-PAIR (SOLVE THOSE PESKY CONTACT PROBLEMS) ($9.00 Pair)
Add this item to your shopping cart - you can always remove it later!

 


Little British Car Co, Ltd. / Vintage Motors, Ltd.
29311 Aranel, Farmington Hills, MI 48334-2815, USA
Contact: Jeff Zorn Tel: 248 489 0022 or 800 637 9640 Fax: 248 489 9665

E-Mail is always the preferred method of communication.
By using E-Mail it helps us to keep our costs down enabling us to pass the savings on to our customers.


Email: <LBCarCo@LBCarCo.com>
Pickup Counter Hours Seven Days a Week by Appointment